Refine Collections

Product Type

Bearing Type

Id

Od

Width

type

Product Group

Manufacturer

Model

Feature

Product Sub Group

Ball Grade

Number Of Balls

Weight

Price Range

In Stock

Number of Pieces

Flange F

Noise Quality

Radial Play

8 X 14 X 4

  • Page
  • of 38
  • Next »
There were no documents that contained all of the words in your query. These results contain some of the words.
Products
Show more Products
Blog

The NC SCT Challenge series raced Saturday 4-16-16 at Glory...

…to more of your products that we can give as prizes to our drivers. Our next race will be May 14, at Zoo City Asheboro, NC. Todd Norder and Jana Eanes NC SCT Challenge Series

I have been able to race 3 times so far this year. 2 races for...

…a 6th, 7th, and 4th in B. The B main was at Thornhill and on the start Brad Ripple spun out and put me on my lid starting last.  Was able to catch transfer 4 times and had bad…

Quarterly Report:Thanks to Boca Bearings my Serpent 747e and...

…to go at extreme speeds. The TC5 will be running 2s and the 747e will be tested on 4, 6 and 8s later on this year. Thanks again for making the fastest and smoothest bearings in the…

We ran at least 2 local club races per month and ran the...

…sessions and finished 1st in A-Main.Strong run in 2WD Mod Buggy put him 4th on the podium.Strong run in 4WD Mod Buggy put him 5th on the podium.Picture attached of young fans…
Show more Blog results
Faq

Q: How often should I clean and lube them and what lube should I use?

A: The only bearings that need to be lubed occasionally are the metal shielded bearings, and they need to be cleaned every 4 - 5 races depending on the length of each race.

Q: I am going through a lot of clutch bell bearings, what can you recommend to get longer life?

…best solution is to use a bearing with a ball that will not expand and to do away with the retainer altogether. We offer 4 different RC Car & Truck Clutch Bell Bearing Kits.

Q: What is the best way to maintain my bearings?

…grease or particulates. 2) Blow bearing out with compressed air. 3) Place a light drop of oil on the bearing. 4) Give the bearing a spin, if they still feel rough repeat steps 1-3.

Q: What kind of performance enhancement should I expect from ceramic bearings?

A: Unfortunately every operator, setup and operating environment is very different so it is difficult to quantify an exact improvement in performance. But in general ceramic…
Show more Faq results
There were no documents that contained all of the words in your query. These results contain some of the words.