Boca Bearings Blog 2017



3D Printer Filament Stand Project

Jul 14, 2017

John Praleston

Today I built a filament stand for our 3D printers. I wanted to hold 24 rolls on the back and will be adding posts for the most common ones up front.


Built from

  • 3 – 2x4x12
  • 10 – ½” dowles
  • Construction wood screws
  • Cost – 50$


This was a simple design but was constructed without the use of power cutting tools. ½” holes were drilled evenly spaced and rods that were cut into thirds were pressed in via hammer.


Project came out nice and organized and planning to 3D print filament feeders and attach them to the stand



filament stand



filament stand