Product Sub Group
Bolt Hole Size Ni
Bolt Size 2-n
Ctr. To Ctr. On Bolt Hole J
Flange Od D1
Flange Width Bf1
Groove And Snap Ring
Nonrotating Wash. Id
Number Of Balls
Od Inner Ring D1
Overall Height Ho
Rolling Element Mat.
Rolling Element Material
Rolling Element Type
Rpm Grease (x1000)
Rpm Oil (x1000)
Working Temp Deg. C
Number of Pieces
- All (8840)
- Products (8827)
- Youtube (2)
- Twitter (8)
- Faq (3)
- of 369
- Next »
Related Categories: Rc | Hybrid | Weight | Ceramic Balls | Full Ceramic
9/16 IN SOFT CARBON STEEL BALLBalls
SKU: 9/16 IN SOFT CARBON STEEL BALL0 x 0 x 0More Info.
3/4 IN SOFT CARBON STEEL BALL (LB)Balls
SKU: 3/4 IN SOFT CARBON STEEL BALL (LB)0 x 0 x 0More Info.
5/16 IN SOFT CARBON STEEL BALL (LB)Balls
SKU: 5/16 IN SOFT CARBON STEEL BALL (LB)0 x 0 x 0More Info.
1/2 IN SOFT CARBON STEEL BALL (LB)Balls
SKU: 1/2 IN SOFT CARBON STEEL BALL (LB)0 x 0 x 0More Info.
ELB Pro Flipper Bearing Upgrade Walkthrough
…through swapping out the steel balls for Ceramic Silicon Nitride (SI3N4) in an ELB Pro Flipper balisong. This knife requires 44 size 1/16" balls which can be purchased here:… 2017-06-07 21:57:05
Installing Ceramic Hybrid Bearings in an Ultimate M3X Engine
…Stainless Steel, Ceramic hybrid, rubber sealed bearings are specially designed for harsh and dirty operating environments. These bearings have ceramic balls, with stainless steel… 2021-11-17 16:05:45
Q: Do ceramic bearings offer significant weight savings overtraditional steel bearings?
A: Ceramic hybrids that have steel races and ceramic balls do not offer a significant weight savings as only the balls are ceramic. Full ceramic bearings however do offer a…
Q: What kind of performance enhancement should I expect from ceramic bearings?
…bearing. This is because ceramic is harder than steel in ball form; it is 3-4 times the Rockwell hardness of a steel ball. As far as performance is concerned, a ceramic bearing…
Q: I am going through a lot of clutch bell bearings, what can you recommend to get longer life?
…the steel balls to expand and subjects the retainer to a tremendous amount of stress, as a result the bearings fail prematurely. The best solution is to use a bearing with a ball…