Refine Results
type
- Products (2046)
- Blog (10)
- Faq (24)
- Page
- of 2
- Next »
Q: What kind of performance enhancement should I expect from ceramic bearings?
…environment is very different so it is difficult to quantify an exact improvement in performance. But in general ceramic bearings are lighter, stronger and faster. Typically you…
Q: What is the best way to maintain my bearings?
…bearings in mineral spirits or paint thinner to remove any grease or particulates. 2) Blow bearing out with compressed air. 3) Place a light drop of oil on the bearing. 4) Give the…
Q: Are the seals fixed or held in place by c-clips?
A: On the removable shields there are c-clips to hold them in place.
Q: How long does it take to break in a bearing?
…the bearing normally and it will break in naturally. The more you use the bearing the more broken in it becomes until eventually it is so broken in that it is time to replace it.
Q: I noticed that your Green Seal RC Car & Truck Bearings are "maintenance free and lubed for the life of the bearing." Would these bearings still be maintenance free if run in wet conditions, or even submerged in water?
…through mud, water and dirt. However if submerged for a length of time it could result in corrosion and subsequent failure. As long as the seals are kept intact they will last you…
Q: How do I calculate the amount of side or thrust load that a bearing can take?
A: Typically a radial bearing can take 5% of its Radial Load in a Thrust Load capacity.
Q: Do you ship internationally and what shipping methods are available?
…items in your shopping cart, proceed to the checkout area. Complete the Shipping and Billing information, including selecting your country. If your country is not in our drop-down…
Q: How often should I clean and lube them and what lube should I use?
A: The only bearings that need to be lubed occasionally are the metal shielded bearings, and they need to be cleaned every 4 - 5 races depending on the length of each race.
Q: How should the Orange Seal bearings be handled before being used?
…Seal bearings with an LD (lube dry) in the part number are supplied dry, without grease or oil. AF2 in the part number means light oil and NB2 in the part number means a heavy duty…
Q: What is the performance difference between the following threetype of bearings: Ceramic Metal Shield, Ceramic Yellow Seal andCeramic Ultra Seal?
…and offer lower friction than the rubber seals. They require a small amount of break in time and are recommended for on-road or indoor use only. They should not be run on water…
Q: How do I properly spin test my fishing reel bearings before installation?
…in period, so comparing new bearings to old worn in bearings is not an apples-apples comparison. We typically just attach an awl to a bearing and give it a spin like shown in this…
Q: How do I remove my shields or seals?
…a small hole. Then peel the shield back with the awl. Removable metal shields are held in place with a retaining ring. Run a sewing needle along the inside of the outer race to pop…