Refine Results
type
- Faq (34)
- « Prev
- Page
- of 3
Q: Are the seals fixed or held in place by c-clips?
A: On the removable shields there are c-clips to hold them in place.
Q: Also, can the greased bearings be used out the box, or should they be treated before use?
A: Yes, the stocked greased bearings can be used as is and will give you great performance.
Q: How do your different RC bearing lines compare to the stock bearings that came pre-installed. How much longer will they last?
A: Unfortunately there is never an explicit warranty with bearings. Bearings do eventually wear out and every application, setup and operator is different. It is very difficult to…
Q: I am going through a lot of clutch bell bearings, what can you recommend to get longer life?
A: The clutch bell is a constant source of problems due to excessive heat buildup. The heat levels cause the steel balls to expand and subjects the retainer to a tremendous amount…
Q: How do I remove the bearings from my RC engine?
A: Place your engine housing in an oven at 325°-350° for 5 to 10 minutes. When you remove it from the oven your old bearings should fall right out, if not heat the engine a little…
Q: The bearings I received have a green shield on one side and a black shield on the other. Should either of these be removed on the back bearing? What about the front? Are these colored differently to indicate direction or does this matter?
A: Firstly the different colored seals do indicate which is the open side on the bearing. The green seal is the one to remove to expose the open side. However, on the front bearing…
Q: Do ceramic bearings offer significant weight savings overtraditional steel bearings?
A: Ceramic hybrids that have steel races and ceramic balls do not offer a significant weight savings as only the balls are ceramic. Full ceramic bearings however do offer a…
Q: I prefer to buy a bearing kit that is maintenance free aspossible. Which bearing kit is the least maintenance intensive?
A: Rubber sealed bearings will always offer the most protection and be the most maintenance free.
Q: How often should I clean and lube them and what lube should I use?
A: The only bearings that need to be lubed occasionally are the metal shielded bearings, and they need to be cleaned every 4 - 5 races depending on the length of each race.
Q: I noticed that your Green Seal RC Car & Truck Bearings are "maintenance free and lubed for the life of the bearing." Would these bearings still be maintenance free if run in wet conditions, or even submerged in water?
A: Our green seal bearings are water resistant, not waterproof. They are the best bearings available for off-road racing, through mud, water and dirt. However if submerged for a…